{"ok":true,"content":"If you operate our controller with a 3-position switch, it works like this:<br><br> - Engine off is 0<br> - Engine on is the %-e here (gas value) per bank<br> - After the engine is switched to AR, the AR gas value is pending.<br><br> Therefore - I always use the %-e for the turbine&#39;s LL (usually 25% or so, depending on the instructions) for AR, with 100% for all 3 banks.<br><br> If I have now set &quot;Startup Sequence&quot; in the ECU, the startup procedure is:<br><br> - Off to On<br> - One according to AR<br> - AR after in (turbine starts)<br> - One after AR (wait until LL is stable in turbine)<br> - AR to Ein to take off<br><br> .<br> .<br> .<br><br> - A deviation towards AR during landing (turbine in LL)<br> - AR after off to turn off<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}