{"ok":true,"content":"Hello Rainer,<br><br> You were on the right track again! Everything looked normal in the channel assignment. No trembling.<br><br> But the log was a shock: at least every second display showed a failsafe message...<br><br> After consulting with Jetcat, I performed a turbine reset. Apparently, the temperature sensor needed recalibrating. I have no idea how it had become misaligned.<br><br> After reviewing the logs, I flashed an older software version onto the receiver and set version 1 for the serial bus... Voila, after that, the calibration and turbine behaved as they should. Since the helicopter repair dragged on for a few months, I&#39;d forgotten that I&#39;d updated the receiver immediately after removing it. Never change a running system \u2013 even when it&#39;s not working anymore...<br><br> I&#39;ll probably be a little nervous before the maiden flight soon. Too many frighteningly strange things have happened.<br><br> Thank you so much for your diagnosis,<br> Werner","note":"machine-translated from German"}