{"ok":true,"content":"Hello Rainer,<br><br> On the opening screen...<br><br> - Switch live: Bar shows exactly the positions Off (bottom) - Idle (middle) - Full throttle (top) - The rectangle External controller: Throttle value 50 Autorot 15 - The bar External controller: Engine off ---&gt; Bar steady at bottom Idle ---&gt; Bar at the level of the failsafe light then a short flash Failsafe bar jumps down, then up-down-up-down again (down always with a short flash of the failsafe light) Full throttle ---&gt; Bar at the level of the autorotation lettering then a short flash Failsafe bar jumps down, then up-down-up-down again (down always with a short flash of the failsafe light)<br> What to do?<br><br> Best regards,<br> Werner<br><br> Update: I just checked again with the GSU. Although the switch&#39;s live bar is steady in its three positions, the displayed pulse value on Aux3 constantly jumps back and forth between 0-980ms, 0-1450ms, and 0-2080ms. The values are displayed without any jumps at the receiver&#39;s channel output.<br><br><br><br> Edited once. Last edited on 10\/11\/2022 at 14:20 by WFEGb.","note":"machine-translated from German"}