{"ok":true,"content":"Hello,<br><br> After a major breakage of my Lama with PHT-2, the Neo seemed to be one of too few of the parts that were still okay...<br><br> During installation and adjustment, I was pleased to find that all previous settings worked again, except for:<br><br> The ECU\/throttle\/gas control is set as &quot;External Controller&quot; (with reset) in controller menu 1. Only the three positions off-idle-full throttle are needed. This worked perfectly fine before.<br><br> Since the turbine was also being inspected, I wanted to program the three throttle positions using the GSU. Unfortunately, that didn&#39;t work.<br><br> - From: Works as expected<br> - Idle: When the car starts moving, it then jumps wildly between off and idle.<br> - Full throttle: The car starts moving, but then it wildly switches between off, idle and full throttle.<br><br> There was great concern after the setup, when the turbine (in the basement!) started running and could only be stopped by disconnecting the battery. Fortunately, it was just a cooling run.<br><br> This behavior is also evident when testing with a servo connected instead of a turbine.<br><br> What&#39;s going wrong?<br><br> Best regards,<br> Werner","note":"machine-translated from German"}