{"ok":true,"content":"Dear helicopter community,<br><br> I&#39;m finally upgrading to a Mikado Logo helicopter and VBar system from the old 40 MHz model, completely rebuilding it, and am currently struggling through the settings.<br><br> Transmitter: Futaba T10CHG<br> Model: Mikado Logo 550 SE<br> VBar: VBar Neo<br> Controller: Scorpion Tribunus II 06-120A ESC<br> Servos: Sav\u00f6x<br><br> The previous owner had the model fly perfectly with a Vbar Control Touch. However, I&#39;m trying to program the model to my Futaba T10CHG transmitter. For this, I&#39;m using a suitable S-BUS receiver.<br><br> The following basic settings currently work:<br> 1. Registration, software and connection of Futaba transmitters with Vbar Neo<br> 2. Swashplate and tail servo function<br> 3. Pitch and Run \/ Gas (controller only works in hover mode \/ bank)<br><br> Where I can&#39;t proceed despite reading the instruction manuals:<br> 1. Switching between flight modes (hovering \/ aerobatics) \/ switch naming and setting, etc.<br> 2. Rescue function setting \/ switch name<br> 3. Autorotation circuit<br> 4. The instruction from the VBar NEO manual, &quot;If you want to adjust the head speed (external controller) via the transmitter as before - then forward the corresponding channel to AUX3 (and only there) at your own discretion,&quot; cannot be implemented because the controller is not responding (previously plugged into the ESC and working).<br><br> Could someone please offer some advice? I&#39;d also be grateful for a tip on who might be able to help me set up the model, especially since I&#39;m a Mikado beginner. I&#39;d even be willing to travel 100-300 km with the model (if not based in Berlin) and would gladly compensate them for the effort. I&#39;d simply like to progress and get flying ;-)<br><br> Thank you so much in advance!","note":"machine-translated from German"}