{"ok":true,"content":"Hello!<br> I need to write again in German. I spent 6 hours today trying to establish a connection between the Evo Stabilizer and a satellite receiver, but so far I haven&#39;t had any luck.<br> My remote control is a Radiomaster TX16SMk2 with an internal multiprotocol module and an external ELRS module. This means I can connect to pretty much all commercially available receivers with it.<br> 1. Attempts: I have now tried 3 different ELRS receivers, which output CRSF (RX and TX), behind which I have a MATEKSYS signal converter from CRSF to SBus.<br> 2nd attempt: I connected an OrangeRX D16N with SBus output <a href=\"https:\/\/hobbyking.com\/de_de\/orangerx-2-4ghz-dd16n-nano-d16us-eu-frsky-diversity-sbus-receiver.html\" target=\"_blank\" rel=\"noopener noreferrer\">D16N<\/a> .<br> 3rd attempt: I connected an OrangeRX R617XL with DSM output <a href=\"https:\/\/hobbyking.com\/de_de\/r617xl-dsm2-x-6ch-receiver-with-long-antenna-and-cppm.html\" target=\"_blank\" rel=\"noopener noreferrer\">R617XL<\/a> .<br><br> All receivers were bound, and the channel numbering is correct. However, I see no reaction from the VBar, neither on the PC nor on the servos.<br><br> For your information, I don&#39;t intend to fly with the OrangeRX, but I would like to be able to make some adjustments on the workbench and check if the servo travel and zero positions are correct, and I&#39;m slowly getting desperate.<br> It can&#39;t be that I have to spend a lot of money again on a VBar Control just to get the VBar working, when the options are offered in the software. I&#39;ll certainly get a suitable transmitter eventually, but it&#39;s simply not possible this season. :-\/","note":"machine-translated from German"}