{"ok":true,"content":"1:4.5 oh wow... that&#39;s not much...<br><br> My PHT3-3 has a gear ratio of 1:4.67, and I also have the Vario spiral gear set at 1.0635 on the tail gearbox. That makes a total of 4.96. Plus, I only have the basic torque of two blades (of the same length) instead of four. Takeoff weight is 21.8 kg.<br><br> Normally, 4-blade thelis in the same weight class operate with smaller rotor circles than their 2-blade counterparts. Therefore, we have high drag here, primarily due to the four large blades \u2013 despite a lighter weight than mine. However, the centrifugal forces of the tail blades might also be a factor \u2013 it&#39;s possible that these large blades exert a strong pull, causing the thrust bearing to seize.<br><br> Quote: Finally, I ran the Bell without rotor blades while stationary and operated the tail rotor manually (i.e., via the linkage near the servo). Everything works smoothly with very little effort and without any problems.<br><br> If you feel confident enough (have someone hold the tail!!!) - try it with the blades. Don&#39;t worry, they&#39;ll center themselves first. Then operate them - but be careful - and always keep one hand on the motor OFF! - If it&#39;s difficult to turn, try using propeller torque weights (PMGs), check the thrust bearing, or try different large tail blades.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}