{"ok":true,"content":"Hello everyone,<br><br> I have the following problem with my new and standard Bell 430 (1:5 scale, Vario kit and mechanics, Kontronik motor and controller):<br><br> If I want to fly a tail turn very slowly, the tail turn is not consistently smooth, but somewhat jerky.<br> I have already tried all possible solutions I know of:<br> The tail rotor blade bearings were replaced as a precaution, even though they were only a few months old. Everything moves smoothly, even under load. No improvement.<br> - The tail control mechanism was completely redesigned compared to the standard version (thicker carbon fiber tube, play-free and absolutely smooth operation, even under load). No improvement.<br> - The tail servo has been replaced a total of three times (first Hitec, then MKS, now KST). None of the changes brought any improvement.<br> - Switched from Axxon to VBar Neo. No improvement.<br> - Tried various Neo settings (tail rotation rates, etc.). No improvement.<br> - Drive unit (tail rotor, tail shaft, stainless steel, standard) disassembled several times and checked for slippage or other damage. No improvement.<br><br> Finally, I ran the Bell without rotor blades while stationary and operated the tail rotor manually (i.e., via the linkage near the servo). Everything works smoothly with very little effort and without any problems.<br><br> I&#39;ve exhausted all my solutions. This has been going on for about a year now. I could replace the tail rotor, but then more customers would have to be experiencing the same problem. Therefore, I don&#39;t think that would help.<br><br> Logically, the only explanation I can come up with for this behavior is that the control loop is essentially oscillating. That is, the signal comes from the transmitter, nothing happens at the tail, Neo compensates further, but now too much, compensates again, now too little, and so on. The cause is either the mechanics or the settings. However, I have checked, modified, or changed both.<br><br> Perhaps one of you might have some advice. Thanks for any help.","note":"machine-translated from German"}