{"ok":true,"content":"Hi Eddi,<br><br> I had imagined the truncated cone as follows: at zero pitch, the cyclic ring always allows the full cyclic deflections regardless of the value specified in the swashplate dialog (that would be your circumcircle around the corners of the square), whereas at full pitch, the cyclic deflection is increasingly restricted depending on the height of the specified value.<br><br> To put it figuratively, this would be a truncated cone with a large circular diameter at its base in the xy plane. As the pitch increases (pitch being the value on the z-axis), the diameter becomes progressively smaller, thus limiting the possible cyclic deflection \u2013 theoretically down to 0 if 0 is entered as the default value. Then the truncated cone would become a cone.<br><br> The way you describe it, the cyclic ring might engage even at zero pitch, for example, if someone were to mechanically set 14 degrees of cyclic deflection. That could actually make sense; I hadn&#39;t considered that possibility before.<br><br> Be that as it may, I think we have discussed the topic in sufficient detail and can close it here.<br><br> That was very informative and helpful for me.<br><br> Thank you so much, Eddi.<br><br> Warm regards,<br> Peter","note":"machine-translated from German"}