{"ok":true,"content":"Hello,<br><br> As someone switching from the HC3 SX to the VBar Neo, I don&#39;t really understand the function of the cyclic ring yet. There&#39;s no setting for it on the HC3 SX.<br><br> When configuring the rotor head, I specify default values for maximum pitch, maximum roll, and maximum pitch. In my case, that&#39;s 12 degrees of pitch and 8 degrees each for roll and roll. Ultimately, however, I&#39;m only defining default values for the maximum rotation rates, which are in turn influenced by the VBar settings in the three banks. So, I don&#39;t know what actual mechanical deflections my VBar will generate in flight.<br><br> Therefore, I&#39;m wondering: if I adjust the cyclic ring on the workbench so that nothing mechanically hits it, is it absolutely certain that the same applies in flight?<br><br> I&#39;m asking because I couldn&#39;t find any clear information about this in the manual. While browsing the forum, I read somewhere that the cyclic ring should be configured at 50% (or 75%?) pitch and simultaneously full roll and\/or full pitch. However, this doesn&#39;t correspond to the maximum rotation rate across three axes that could theoretically be set by the transmitter.<br><br> The statement &quot;you never really control that anyway&quot;, which I read elsewhere in the forum, does not satisfy me.<br><br> Can someone explain to me in simple terms how this works and how I should proceed with the setup?<br><br> Best regards,<br> Peter","note":"machine-translated from German"}