{"ok":true,"content":"Hello,<br> Since I only want to use the rescue function and not the hover mode, I have set up my kit as follows:<br> Flybarless VBAR NEO<br> GRAUPNER MX-16 transmitter with<br> Receiver GR-16<br><br> Discontinuation of rescue services on May 19, 2024<br> Images of the GRAUPNER MX-16 transmitter<br> Transmitter setting 2-stage push-button switch SW9 for channel E5<br> and servo setting channel E5 travel + to 0%<br><br><br> Transmitter setting Channel E5 SW9 Active<br><br><br> Transmitter setting Channel E5 SW9 Off<br><br><br> Servo indicator channel E5 active<br><br><br> Servo indicator channel E5 Off<br><br><br><br> According to the VBar setup, everything works fine.<br><br> Registered recipients<br> Rescue Active<br><br><br> Rescue From<br><br><br> Register Sender<br> Rescue Active<br><br><br> Rescue From<br><br><br> Now, let me answer my question from the initial post: when pulling the 2-position push-button switch SW9 on the ground, with the helicopter in normal flight, the swashplate responds with a slight positive pitch, before slowly returning to its starting position. This works as many times as the switch is pulled consecutively on the ground. Therefore, the behavior I described in my initial post, &quot;only works once,&quot; was incorrect.<br><br> Greetings from Grafenau<br> Ronny<br>","note":"machine-translated from German"}