{"ok":true,"content":"Hello Christoph,<br><br> Basically, any cable can pick up &#39;something&#39;; it&#39;s practically an antenna.<br><br> The 3.3V signal line(s) (also servo, telemetry, etc.) may be particularly sensitive.<br><br> With short cables or, if necessary, interference suppression measures, the risk is low. This works in practice with all systems.<br> Distance to the power electronics is also essential... just think about where some designers think you could\/should put gyros or receivers... not smart... but I digress.<br><br> In addition, the electronics inside the VBar are protected and stabilized as well as possible against fluctuations in the supply voltage, whereas an external receiver has to take care of itself... the RX-Sat does this too, of course, but the circuit built into the VBar has virtually double protection, as Rainer writes.<br><br> It&#39;s a familiar phenomenon elsewhere that capacitors, used as buffers or to smooth the supply voltage, have resolved &quot;reception problems&quot; that weren&#39;t actually problems. The capacitor doesn&#39;t improve the radio signal itself, but it helps the receiver (and the rest of the electronics) to operate smoothly.<br><br> On the other hand, there can also be good reasons for a satellite dish, such as installation position, antenna positioning, or other factors.<br> It&#39;s a matter of weighing the options.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 14.08.2024 10:52 von Eddi E. aus G..","note":"machine-translated from German"}