{"ok":true,"content":"See YGE 135 instructions - I&#39;m not a Jeti expert... E1 = channel 6, E2 = channel 7 on the REX7 (according to the internet), here&#39;s the blue cable from the controller... see controller instructions (excerpt below)...<br><br> Best regards, Geri<br><br> Jeti ExBUS:<br> Configure the E1 or E2 channel of the receiver.<br> on Jeti ExBUS (not EX!) and connect the<br> Telemetry cable (blue connector) with this channel.<br> The controller must also be configured in the PC software on Jeti ExBUS.<br> can be configured. In the Jeti-Box menu of the transmitter, you can...<br> The most important controller parameters are then also displayed.<br> Adjust them directly on the transmitter. You will find the controls there.<br> Settings here under &quot;Mx&quot;.","note":"machine-translated from German"}