{"ok":true,"content":"Hi Eddi,<br><br> Thank you very much for your explanation. Of course, for me it doesn&#39;t matter where the tail is positioned after a rescue from an inverted position. As I said, although I&#39;ve been flying the Neo in my Logo 600 SE for nine years, I&#39;ve only adjusted the rescue system (with a little more pitch so the helicopter climbs a bit faster) and have only tested it in normal flight (tail towards the pilot). The helicopter climbs nicely, doesn&#39;t drift out of pitch or roll, and the tail stays put. I haven&#39;t had time to look at the tail setup yet. I&#39;m certainly not as meticulous about tail settings as some other pilots might be. In aerobatic maneuvers, I haven&#39;t had any problems with the tail twisting out (overspeeds, reverse loops, roll loops, funnels, etc., don&#39;t unsettle the tail). However, I wanted to take another look at the servo travel (very different values in the wizard?), check if the tail optimizer is permanently enabled, and see if the angle of attack of the tail blades makes aerodynamic sense. Perhaps I can increase the tail sensitivity even further; the Sav\u00f6x 1290 requires more than servos from other manufacturers. It can&#39;t hurt!<br><br> Thank you again and best regards<br><br> Christoph","note":"machine-translated from German"}