{"ok":true,"content":"Hi Eddi,<br><br> First of all, thank you so much for your support, I really appreciate it!<br><br> To be honest, I haven&#39;t really paid attention in the past to whether the circuit board moves slightly inside the housing or not. When problems arise, like the IMU error, you tend to notice the smallest things. The board moves very easily inside the housing. You can even hear it slightly when you move the VBar back and forth. I don&#39;t know if this is the case with the other Neos I have. Usually, I secure the cables with a bit of hot glue at the end, and then nothing moves anymore. I didn&#39;t do that with this Neo because the connectors were so tight that nothing moved even without securing them.<br> Regarding your question: I have a total of three Neos registered, the one being from 2016. I haven&#39;t flown it that much, though (not since around 2018). The Neo is mounted in a GAUI X3 on the bottom plate (not, as is usually the case, on the platform above the tail boom mount). I also had a crash with the helicopter at the end of 2016, so the Neo was certainly indirectly impacted (the chassis, side plates, and bottom plate remained intact). I didn&#39;t fly the helicopter as often after that because the larger ones are simply more fun for me. Besides, there was always that IMU error, and initially, I still had the precision calibration enabled, so I was flying with the &quot;red&quot; Neo. My dealer, from whom I bought my helicopter equipment back then, said that wasn&#39;t a problem. You just mustn&#39;t use the rescue system. It went well, but I still have a nagging feeling, and I wouldn&#39;t want to do that with a larger helicopter. I&#39;ve refrained from sending it in for service so far because you all mentioned in the forum that a check wouldn&#39;t be very useful. Besides, the Neo lights up green when I revert to the standard calibration.<br><br> Warm regards<br><br> Christoph","note":"machine-translated from German"}