{"ok":true,"content":"Hi Christoph,<br><br> Normally, if you only plug in a servo connector and wiggle it up-down-right-left, you should be able to see if anything is moving &#39;illegally&#39;.<br> When 4, 5, or 6 servo connectors are plugged in, the circuit board is quasi-automatically additionally secured.<br> In most cases this is &#39;sufficient&#39;, so there is no need to fear any negative effects.<br> Otherwise, we wouldn&#39;t fly and sell it ourselves.<br><br> There are always exceptions.<br><br> It&#39;s also possible that the sensor is already damaged due to prolonged, intensive use (from vibration), or perhaps even due to some mishap. Even if the VBar shows no external damage after a tip-over or crash, it&#39;s like throwing it, with varying degrees of force, against a solid wall. Everyone would immediately say, &quot;You don&#39;t do that; it&#39;s obvious something could happen!&quot; But with a helicopter crash or tip-over, well, what could possibly go wrong? This isn&#39;t meant to be an accusation; I&#39;m just offering possible explanations.<br><br> It seems you have two stabilizers registered, one from 2016 and the other from 2019, and they both probably have quite a few miles on the odometer... which one is it?\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}