{"ok":true,"content":"Hi Olaf,<br><br> If Pro (or +Rescue) is installed, it can be found in the Main Rotor\/Expert menu (doctor&#39;s hat).<br><br> Normally, the parameter should be set to zero in the factory default state.<br> However, there were cases where the (cause still unclear...) setting was 35 in all banks (switching through the banks using the transmitter&#39;s switch).<br><br> With Express, it&#39;s annoying because it&#39;s not easily accessible. But for this one parameter, a trick might help, if that were the case:<br> Start VBar software _without_ a connected VBar<br> . Main rotor \/ Expert click<br> Now connect the VBar \u2013 the Pro Parameter window remains open.<br> zeros (in all banks)<br><br> This doesn&#39;t work for the other parameters; they (in Express mode) are always automatically reset to factory settings, no matter what you try. However, as far as I know, you can reset the lightness setting this way.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}