{"ok":true,"content":"Hi Olaf,<br><br> Yes, that&#39;s normal because control loop components are already active outside the setup. This means that, in addition to pitch, you might also measure slightly more or less roll or pitch.<br> Or it is set to &#39;lightness&#39;, which statically shifts the pitch curve upwards when viewed on the ground (downwards when inverted), but is\/is additionally influenced by the sensors in flight.<br><br> Therefore: only measure in setup mode, making sure that you don&#39;t get any mechanical problems at 50% pitch pos.\/neg. and cyclic full deflections to the corners, and if lightness is set, try the latter again with a temporarily increased pitch range.<br> In practice, it&#39;s not very relevant; &#39;it simply works as intended&#39; :-) \r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}