{"ok":true,"content":"<hr><br>&lt;Live Support&gt; :-)<br><br> Rainer, Uli, is it possible that if a NEO VLink, which is controlled via UDI\/SUMD on AUX1, has controller telemetry (here YGE) connected to TELE (here to 1), this could interfere with or compete with the external receiver signal? Depending on the configuration, both are possible receiver inputs.<br><br> Background:<br> Everything is fine with VLink.<br> Customer receiver bound to MX-12*, YGE BEC 7.9V, with switching to LS function for live logging on the transmitter for convenience, a &#39;satellite packet error&#39; occurs quite soon. -&gt; Customer complaint essentially confirmed.<br> Same, BEC** 5.9 V, same. -&gt; It&#39;s not due to the voltage as previously suspected.<br> Own GR-12 re-bound*, same issue, or even permanently reverts back to the teacher \u2013 interesting, if you toggle the input in the macrocells without a power-down in between, TELE, then UDI again, it works again. -&gt; Assumption: enough packet loss so that switching back isn&#39;t possible, some kind of overflow?<br> Same setup, but with a 7.9V lab power supply, YGE left connected but without the flight battery... all quiet on board. -&gt; This mirrors the test with the receiver battery, which also wasn&#39;t reproducible for the customer.<br><br> Preliminary conclusion:<br> The YGE telemetry connected and configured to TELE 1 _seems\/could_ &#39;mess up&#39; the AUX1 input.<br><br> This isn&#39;t anything terribly bad at first glance; normally, either VLink with telemetry or a third-party receiver with\/without its own telemetry is used, and as a rule, it&#39;s not flown in a cross-trainer\/student configuration with UDI (because, for example, HoTT\/Jeti\/Multiplatsch have their own telemetry and could potentially interfere with each other), but rather with Futaba or Spektrum.<br><br> I&#39;ll test it a few more times, then disconnect the ESC telemetry from the stabilizer, and also check the test with a different stabilizer, a different ESC, and a Graupner as the input. That&#39;s enough for today!<br><br> Greetings<br><br> Eddie<br><br> Graupner, seriously!?<br> MX-12, not used in ages, memory blank... the binding dialog couldn&#39;t be found at first.<br> I eventually figured out that _if_ I turn off RF, I can bind _if_ I click on the previously\/currently bound receiver.<br> UDI configuration in the second-to-last telemetry menu, I vaguely remembered it... and then not immediately recognizable as such until you open the (disguised) setting and scroll through the options, oh, SUMx$$##... it really took me almost half an hour to bind a receiver and set the protocol... wow.<br> I haven&#39;t exactly covered myself in glory, and I admit it, but... then I imagine a clueless beginner... #TotalLoss...<br> I much prefer the simple &quot;dip, tap, pling-plong, done&quot; approach :-)<br><br> **Adjustable via VBar Control during ongoing test operation without restarting, g$$l :-)<br><br> Born to fly ...<br> forced to work.","note":"machine-translated from German"}