{"ok":true,"content":"Excellent drawing! Thank you! From an electrical engineering perspective, this is very good. There are no disruptive currents, etc.<br><br> The cable to AUX3 is the only one that wouldn&#39;t be needed, since in this configuration we&#39;ll likely be using VGov or YGE Gov with RPM %-e via bank. If you want to use YGE Gov and adjust the RPM &amp;-e in the TX, the &quot;Receiver&quot; would need to be connected to the throttle channel on the RX.<br><br> But - according to BA, the ESC has two BEC outputs:<br><br> <a href=\"https:\/\/www.yge.de\/wp-content\/uploads\/2022\/04\/YGE-205HVT-BEC.pdf\" target=\"_blank\" rel=\"noopener noreferrer\">https:\/\/www.yge.de\/wp-content\/uploads\/2022\/04\/YGE-205HVT-BEC.pdf<\/a><br><br> And based on experience (I have it in my Logo 800), I know that the connector on the controller is a bottleneck. Please use both BEC cables. You can either connect them to the RPM pin or assign them to channel 4.<br><br> Suggestion:<br> - 2. BEC reconnected<br> - Remove AUX3\/CH1, it doesn&#39;t have any function anyway.<br> - Test again, once without and once with servos<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}