{"ok":true,"content":"So if I understand you correctly, in the attempt from last night, only the receiver and the power supply via the controller were connected to the VBar in the first attempt, after that only 1 servo was added.<br> No abnormalities.<br><br> And on the second attempt, with no servos connected, only the two-wire cable to the ESC and additionally the single-wire cable to the RPM input of the NEO. Then, approximately 12 or 15 minutes of failsafe.<br><br> I performed both attempts twice.<br><br> Tonight I just wanted to connect the servos together again and see what happens.<br><br><br> If by &quot;second attempt&quot; you mean the attempt with the receiver battery and 5.9 volts, then all consumers were connected and the power supply did not go through the regulator.<br><br> Unfortunately, I don&#39;t have an oscilloscope, and I last used one 25 years ago. :-\/<br><br> Greetings","note":"machine-translated from German"}