{"ok":true,"content":"Hello Eddi, hello Mr. Vetter.<br> First of all, please excuse the late reply, but I was away for the past few days.<br><br> I switched the receiver to SUMOFD08, but unfortunately that didn&#39;t change anything. Eventually, the Neo goes into failsafe mode.<br> Nor does the change from PERIOD 20ms to 10ms.<br><br> When I do a cross-check and connect this intended receiver to my other Neo in the Nitro, I have no problems.<br> And so, inspired by Eddi&#39;s suggestion, I decided to try changing the voltage or input voltage and powered everything with just a receiver battery (5.9 volts). Lo and behold, even after 30 minutes of inactivity, there were no more dropouts.<br> I&#39;ve tested it several times now. I also connected the 12S battery again and powered it via the ESC. The result is always the same. Powering it via the ESC with 8.4 volts failsafe, and with 5.9 volts, everything is stable.<br><br> Well, my only option seems to be to get a servo limiter for the receiver&#39;s power supply and maybe another one between the receiver and the AUX input for the Neo, although I don&#39;t know if that&#39;s a good idea. And actually, that can&#39;t be the right solution.<br><br><br> Do you have any other ideas what I should change on the receiver? I&#39;m really at a loss otherwise, except, if that&#39;s even possible, but that can&#39;t be the point, to deactivate the failsafe in the Neo.<br> But please don&#39;t say: Buy a VBar control unit. (I know, it&#39;s on the tip of your tongue :-) )<br><br> Surely I&#39;m not the only one flying with Hott and Neo?!?<br><br> Best regards","note":"machine-translated from German"}