{"ok":true,"content":"Good morning,<br><br> As Rainer already writes, try OF (without (receiver) failsafe and 08 (channels) if possible.<br> This has always worked since then, except for GR...L receivers, which, to my knowledge, have never worked.<br><br> VBar activates failsafe when it detects it (i.e., when no valid or no signal is received).<br> HD (HolD) would mean the Graupner receiver needs to be programmed appropriately in case of a transmission error on the radio link. But hardly anyone does this, hardly anyone knows about it, especially since having the throttle on Hold would be bad, because the model would then wander off with the motor running.<br> This means that by switching off the transmitter you probably cannot reproduce the error, because the receiver will continue to output control information (Hold) to the VBar, and it must assume that this is desired.<br><br> 08 or 10 are the channels that are transmitted via UDI (SUMD in Graupner terminology).<br> As I said, 06 (GR12) or 08 (GR16) have always worked to my knowledge.<br> At 10 or higher, for example, the channel spacing might be different than originally thought; you just don&#39;t know...\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n2 mal bearbeitet. Zuletzt am 09.10.2024 09:14 von Eddi E. aus G..","note":"machine-translated from German"}