{"ok":true,"content":"I suspect: The wrong protocol was set at Graupner.<br><br> We specify SUMD0F. This was also used for testing at the time. I only partially understand the difference; 0F means that the Graupner receiver sends us NOTHING in ITS failsafe case, so we can log and identify this (see log); otherwise, its failsafe data would be valid.<br><br> However, the HD10 &quot;at the back&quot; bothers me here. It might be a slightly different protocol than the SUMD specified (Futaba S.Bus is also NOT compatible with S.Bus2).<br><br> Please set it up as instructed.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}