{"ok":true,"content":"Hello collective intelligence.<br><br> During the setup of my Neo (black) and Graupner transmitter MZ-16, I noticed that the Neo keeps going into failsafe mode!<br> My receiver has the same settings (SUMDHD10) as the one for another Neo (blue-aluminum).<br><br> I have already tested different receivers and also tried a different transmitter.<br> But even if I don&#39;t have the PC connected, i.e., I&#39;m not in the setup and the helicopter is just on the ground, the Neo eventually goes into failsafe mode.<br> I can&#39;t reproduce this error except by switching off the transmitter. Sometimes it happens after 2 or 3 minutes, other times only after 20 minutes. So, for me, it&#39;s completely random and therefore impossible to fly the helicopter.<br> The other Neo doesn&#39;t have these problems. But it should work, since Daniel recently set up and flew the helicopter for me. However, he used VBar control.<br><br> I always get these messages in the log file:<br> OK 5:50 Everything is OK (10 sec)<br> Warning 5:56 RC input package lost<br> Info 5:56 Package from satellite out of synchronization<br> Warning 5:57 RC input package lost<br> Critical 5:57 RC Falisave was activated<br> OK 6:07 Everything is OK (10 sec)<br><br> Are you familiar with this problem, and am I doing something wrong?<br> Attached you will find the complete log file, and hopefully you can give me some advice.<br><br> Thank you very much and greetings to all<br> Holger file attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=28036,filename=log-20040860-30-09-2024-23-42-02.zip\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=28036,filename=log-20040860-30-09-2024-23-42-02.zip,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - log-20040860-30-09-2024-23-42-02.zip (1.9 KB)<br>\n                    \n                ","note":"machine-translated from German"}