{"ok":true,"content":"I tried out my TDR again today and urgently need help.<br><br> Even as the rotor spins up on the ground, it&#39;s noticeable that the helicopter wants to drift forward. Even as the rotor stops, you have to keep the helicopter pitching backward to prevent it from tipping forward.<br><br> If the helicopter is switched on for a longer period of time, it appears that the left servo travels a longer distance than the right one on pitch, causing the swashplate to change around the roll axis.<br><br> What&#39;s going wrong here? In VBar&#39;s setup mode, the swashplate is perfectly level. As soon as you exit setup mode, it changes its orientation when pitching up and down. I&#39;ve attached the setup file.<br><br> My colleague&#39;s TDR&#39;s swashplate always runs straight, regardless of whether setup mode is active or not. I&#39;m really stumped at the moment and would appreciate any advice. I wouldn&#39;t have a problem with the swashplate being tilted, but I&#39;m a bit worried about the helicopter wanting to tip over as soon as the rotor starts spinning up.<br><br> What&#39;s also strange is that after several minutes of trimming (confirmed by two pitch twitches), the indicator light in the PC software is still red and no trim values are entered. Why does the gyro display a forward pitch value in the live pitch indicator, regardless of the control input and pitch position, when I manually tilt the helicopter forward and backward? Could this be related to my forward drift?<br><br><br><br> Edited 4 times. Last edited on 28.08.2013 at 01:01 by <a href=\"mailto:gerhard.kaeb@web.de\">gerhard.kaeb@web.de<\/a> .<br><br> File attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?16,file=15617,filename=VBar_4_Setup_TDR.vbr\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?16,file=15617,filename=VBar_4_Setup_TDR.vbr,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - VBar 4 Setup TDR.vbr (5.5 KB)<br>\n                    \n                ","note":"machine-translated from German"}