{"ok":true,"content":"Hello Witold,<br><br> Considering that no tail fins were mounted yet, I find the vibration level quite high.<br><br> Hold your fingernail against the rotating shaft and see if you notice any slight unevenness.<br><br> The TDRs last had a tail rotor gear ratio of 4.93; according to the internet, older models had 5.1. In both cases, the displayed 10,300 rpm doesn&#39;t exactly match the rotor speed of 1,900 rpm you stated.<br> I certainly hope you have configured your translation between electric motor and rotor shaft correctly in the J-Log.<br><br> I would still guess it&#39;s the tail rotor.<br><br> Things get really interesting with the tail rotor blades installed. I&#39;d definitely recommend taking a look. But please disconnect the tail rotor control linkage first (disconnect the ball joint of the linkage at the L-lever).<br> If the tail wave is not perfectly straight, it can generate such strong vibrations above a certain speed that the sensors are disrupted.<br><br> I&#39;m speaking from painful experience. With my helicopter, the vibrations were caused by an imbalance in the tail rotor blades. This led to the helicopter suddenly drifting to the left via roll. I barely managed to bring it down safely. Even after landing and switching off the engine, the helicopter still wanted to tip over onto its left skid and had to be pushed to the right (not by hand, but via the remote control ;-) ).<br><br> It probably wouldn&#39;t have been a problem for Kyle Dahl, but I didn&#39;t find it that funny.<br><br> That was obviously my mistake. I should have done a vibration analysis after installing the tail rotor blades. I simply relied on the blade manufacturer&#39;s information.<br><br> Regards, Wolfram","note":"machine-translated from German"}