{"ok":true,"content":"It&#39;s strange.<br><br> I gave up on it last night on my laptop because the connection stopped working.<br> Today I couldn&#39;t get a connection at all on the computer.<br> Then I went straight back to the laptop and tried again there.<br> And look! It&#39;s working again. :-)<br><br> The sequence is always the same after registration and inserting the key file.<br> I start the PC software, then I apply power to the system.<br> Then I wait until the neo initializes (blinking blue). When it has initialized (lighting up green).<br> I connect the Neo to the laptop or PC.<br><br> It works on the laptop, but not always.<br> Sometimes I have to restart the software or turn the helicopter off and on again.<br><br> I have now been able to set up a system and it is working.<br> I only had trouble with the last point.<br> In the controller tab where you learn the motor on and off values.<br> The engine off setting worked without any problems.<br> Thanks to Castel Regeler, the points are pretty close to 100%.<br> The motor shuts off at 100%, and then I lowered it a few more points to 97%.<br> I couldn&#39;t get the engine to run at full throttle...<br> How do I need to proceed again, and which throttle curve do I need to program into the transmitter again so that I reach the specified RPM?<br><br> Regards, Daniel<br><br><br><br> Edited 3 times. Last edited on 10\/07\/2015 at 16:18 by Daniel.","note":"machine-translated from German"}