{"ok":true,"content":"Hello everyone.<br><br> So yesterday I managed to initialize the stabilizer without servos.<br> The log showed that the nickname entries had significant deviations.<br> I still had the old settings from the regular 5.3 in the transmitter.<br> Strangely enough, the nick and pitch were also swapped.<br> I then reset the model memory to start programming...<br> Suddenly I can no longer connect Neo and the PC software.<br> Only the USB symbol flashes green when you connect the Neo.<br> I tried a lot yesterday, but then I just didn&#39;t have the patience anymore.<br><br> Now I&#39;m at my other PC and have installed the drivers and software and inserted the key file.<br> But when I connect the Neo, the same thing happens again.<br> The USB button lights up green but there is no connection....<br><br> Something&#39;s definitely wrong here...<br> It was running yesterday.<br><br> Regards, Daniel<br><br><br><br> Edited once. Last edited on 10\/07\/2015 at 13:04 by Daniel.","note":"machine-translated from German"}