{"ok":true,"content":"Hello everyone,<br><br> I&#39;m currently setting up my Neo on my X7.<br><br> I first registered the neo without servos using bec and then inserted the key file into the control folder.<br> Then I started the PC software and selected the S-bus receiver in the setup.<br> The recipient was immediately bound.<br> Then I immediately finished the setup.<br> I unplugged the Neo.<br> Then I reconnected all the servos and wanted to adjust the helicopter.<br><br> When I apply power to the system, the neo flashes blue briefly, then the swashplate servos start twitching up and down and the neo flashes red.<br><br> What am I doing wrong? :-)<br><br> Regards, Daniel","note":"machine-translated from German"}