{"ok":true,"content":"Hello everyone,<br><br> Yesterday I played around with the settings a bit and configured the basic channel setup before installation. I noticed the following:<br><br> Input signal is set to UDI.<br><br> If I enter a different channel for the rear and confirm the entry with Enter, it still responds to the originally set channel. If the NEO is disconnected from power and reinitialized, the original value is restored in the setup. However, if I switch to a predefined assignment set (M-LINK, HoTT, etc.), the channel assigned to it is applied to the rear. Manual changes still do not work.<br><br> Presumably, the value simply isn&#39;t transferred to the stabilizer when assigned manually?!<br><br> Regards.<br> Helge","note":"machine-translated from German"}