{"ok":true,"content":"For the Neo, the only important thing is to know whether the motor is on or off. This is simply achieved by using a channel controlled by the AR switch. The servo travel and the assignment of this channel for AR are configured under &quot;Receiver&quot;.<br> For example, my Neo receives information about 0% or 100% throttle opening via the throttle channel, i.e., AR on or off, or motor on or off.<br> The ESC throttle settings are entered &quot;bank by bank,&quot; meaning each of the three banks has its own speed. These are set on the main page under &quot;Motor Off&quot; (the label is still to be changed). Under AR, the throttle value for &quot;Motor Off,&quot; usually 0%, is set, since the motor controller shouldn&#39;t be driving the motor at 0% throttle.<br><br> Since I didn&#39;t dedicate a separate channel for this, I simply used the throttle channel (Futaba channel 3) for motor on\/off and set each &quot;throttle curve&quot; to 100% in the transmitter. For AR, of course, it&#39;s 0%. Therefore, the receiver menu then displays &quot;motor on&quot; or &quot;motor off&quot; depending on the corresponding switch position.<br><br> It sounds strange, but that&#39;s how it worked.<br><br> My GovI menu says &quot;external controller&quot;.<br> I left everything at the default settings in the GovII menu.<br><br> And as Ulrich already mentioned, the lamp is irrelevant for AR.<br> The purple bar nicely shows how much of the controller opening is currently being output.","note":"machine-translated from German"}