{"ok":true,"content":"Please stay on topic. There are plenty of solutions for this one case, as Eddi already mentioned. You can simply loop the signal through either using an aux channel or by using the receiver directly. Everything&#39;s fine.<br> The NEO simply needs information about whether the motor is on or off, or whether autorotation is enabled. The algorithm then adjusts accordingly. If you don&#39;t want this, simply set the motor channel to &quot;always on&quot; and disable these functions. Then, as mentioned, connect the external controller to the aux input or receiver. Similarly, you can assign the backswitch to a channel that simply provides &quot;always on&quot; and disable its functions.<br> When connected to the receiver or Aux input, you can also use all the transmitter&#39;s functions, such as throttle curves and throttle limiter. To complete the setup, you then need to link the virtual motor switch in the NEO to the actual motor switch. I think that virtually every transmitter has similar capabilities.<br> There are simply more features now; you just have to take that in. I can completely understand that some people might not grasp it right away, but that&#39;s what the forum is for.<br><br> So long... Uli<br> <a href=\"http:\/\/www.vstabi.de\" target=\"_blank\" rel=\"noopener noreferrer\">http:\/\/www.vstabi.de<\/a><br><br><br><br> Edited once. Last edited on 10\/07\/2015 at 18:38 by ulrich.","note":"machine-translated from German"}