{"ok":true,"content":"Did you program it exactly as intended?<br> Was a new setup also performed?<br><br> We absolutely need the motor switch. A few other things are connected to it.<br><br> You can also see the output on the throttle bar in the PC \u2013 that&#39;s exactly what should be displayed on the ESC as well. If in doubt, connect a servo to observe the output instead of the ESC.<br><br> If the ESC doesn&#39;t respond (but the bar and a test servo do), it might not be arming (please check). In that case, its travel isn&#39;t properly calibrated. To calibrate it, use the same procedure (stick mode in Gov2, stabilizer constantly powered) as shown in the V5 videos for the 90 LV. Alternatively, you can simply adjust the travel in Gov2 until it arms or reaches full throttle.<br><br> By definition, our failsafe is &quot;the motor off position&quot; (Gov2 tab) when no signal is received from the receiver. If the receiver continues to send signals despite transmitter failure, then the failsafe must also be set in the transmitter. But that was already the case with V5 and VGov \u2013 and now applies to everyone.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i><br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 10.07.2015 06:43 von RV.","note":"machine-translated from German"}