{"ok":true,"content":"Hello!<br><br> I wanted to test the Neo for external receivers with Futaba S-Bus, but I&#39;m having a problem I can&#39;t figure out.<br><br> Neo Update, registration, and saving the key worked perfectly.<br> The S-Bus receiver is bound to the transmitter.<br> If I want to adjust the stabilizer, I use Futaba S-Bus with standard channel assignment.<br> USB is connected and the light in the software is green.<br><br> The software displays the transmitter&#39;s movements perfectly; I can set pitch, roll, nick, etc. to 100%.<br> The directions of travel are correct and all deflections at the servo endpoints can be wonderfully represented with 0-100.<br> The connection between the radio and the Neo must therefore be established.<br><br> When I get to the &quot;swashplate servo&quot; point and insert the servos into the Neo in the corresponding slot (ground at the bottom, signal at the top), they are also powered and move to the center.<br> But then I have no function for the servos to move. Even when I reverse the servos, although it&#39;s displayed as such in the software, I still have no servo signal output on the Neo, and the servos remain stuck in the center position. Neither pitch, roll, nor yaw.<br><br> Is there a solution, or has anyone else had this problem and can help me?<br><br><br> Thanks and best regards, Uli","note":"machine-translated from German"}