{"ok":true,"content":"Hi,<br><br> There are only three banks here; the fourth is basically just a throttle value for autorotation bailout (engine switch center position), but sensitivity, maneuverability, etc. from the currently active actual bank are retained.<br><br> The settings are still bank-dependent where necessary, meaning I can adjust sensitivity, speed, etc. for the currently selected bank.<br><br> Our rescue system is triggered automatically; that is, when the switch is activated, the rescue process continues until the helicopter is in normal flight attitude and climbing. If the rescue cannot be terminated, it ends automatically after approximately 4 seconds, and you regain full control.<br><br> If the switch remains in the rescue position, nothing further (bad) will happen after the rescue, except that you have to move it back to the middle position to be able to initiate the rescue again.<br><br> If you only use a 2-way switch, you would have to limit one direction to 0 so that you get into rescue and off (normal flight mode without rescue, without beginner mode).\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}