{"ok":true,"content":"Hello.<br><br> Yesterday was the first flight with VBar Neo.<br> Now there&#39;s one less Goblin 770...<br><br> First battery - everything OK.<br> It flies very comfortably and everything works.<br><br> Second battery - after about 2 minutes the helicopter spins, the motor shuts off and I can&#39;t do anything anymore.<br> Helicopter falls, suddenly the engine starts again...<br> Everything works!<br> Landed, checked, reinitialized, onwards and upwards...<br> Bank1, Bank2 and the end of the workday.<br> The helicopter falls and nothing comes back!<br><br> Total loss!<br><br> Neo Express via UDI to Jeti DS16<br> Kosmik 200, Pyro 800 Comp<br> Buffer from Linus<br> MKS HV Servos<br> 14 S Blackhorse...<br><br> There have already been countless stabilizers in there, including Silverline, Microbeast, SK 540 and Spartan.<br> This has never happened before...<br><br> Today I calmed down again and plugged the helicopter into USB.<br> Evaluate log...<br> Doesn&#39;t look good!!!<br> I would like to upload it, but it won&#39;t save.<br> It doesn&#39;t really surprise me anymore.<br><br> From RC input packet lost to RC failsafe activated (it says &quot;waste&quot;), everything is included!<br> I&#39;ve also included roll and pitch sensors that are outside the measurement range.<br><br> And that&#39;s only with the second battery!<br> Only vibrations during the first flight...<br> Nothing unusual.<br><br> What to do?<br><br> Regards, Christian<br><br><br><br> Edited twice. Last edited on 15.07.2015 at 15:02 by schnoerki.","note":"machine-translated from German"}