{"ok":true,"content":"Hello Rainer,<br><br> The controller is located in the NEO. When I switch on the power without switching on the controller, the failsafe status light is green, the motor switch is in IDLE mode (I haven&#39;t programmed this state), and the bank is set to 2.<br><br> I just performed the following test. I connected a servo directly to channel 1 on the receiver and programmed a fixed failsafe position. When I switch off the transmitter, the servo moves to this failsafe position. However, the bar in the PC software for channel 1 simply remains at its current value.<br><br> It now seems likely that the failsafe signal is correctly output directly at the receiver output, but not via the summed signal to the NEO. Everything appears to remain on hold. However, even when the controller is switched off, the failsafe status in the PC software does not change to green.<br><br> greeting<br> Holger<br><br><br><br> Edited 4 times. Last edited on 16.07.2015 at 06:28 by Holger Port.","note":"machine-translated from German"}