{"ok":true,"content":"Hello everyone,<br><br> I&#39;m running my NEO with an MZ-18 + GR-16. So far, everything has been super easy to set up. I&#39;m using a 2-position switch for motor ON and motor OFF on channel 6 and a 3-position switch for the banks on channel 8. So everything is as specified except for the motor switch, where I&#39;m foregoing the bailout function.<br><br> On the MZ-18, I&#39;ve now set the failsafe state for channel 6 to -100% (motor OFF). However, when I switch off the transmitter, nothing happens. The motor continues to run, and the failsafe indicator light doesn&#39;t illuminate in the PC software.<br><br> If I switch everything on without turning on the transmitter, the failsafe light illuminates. If I connect a servo directly to the receiver, channel 6 goes into failsafe mode.<br><br> What could be the problem here?<br><br> greeting<br> Holger","note":"machine-translated from German"}