{"ok":true,"content":"I&#39;m doing a bank switch anyway because of rear-end sensitivity, etc.<br><br> So, bank switch 1-2-3 also connects my gas curves in the transmitter. What should I enter for gas value in the software? Always 100?<br> - If I plug the master into the receiver, will the vStabi then receive information about which channel it is (since I can assign it) via smud?<br> - I normally only fly with a 2-way switch, motor off \/ motor on, I don&#39;t need the AR, can&#39;t I leave that out?<br><br> lg<br><br><br><br> Edited once. Last edited on 16.07.2015 at 19:44 by linksen98.","note":"machine-translated from German"}