{"ok":true,"content":"Hello,<br><br> Since I&#39;m getting my neonatal intensive care unit tomorrow, I have a question about the following:<br><br> I run my helicopter on both 12s and 14s batteries. I&#39;ve saved the model twice in the transmitter with different throttle curves so that the RPM is the same for both setups. It works perfectly with the Graupner transmitter... but...<br><br> - In the Neo, the 3 banks are each defined with a specific RPM, but in this case I&#39;m flying with 6 of them...<br><br> - What&#39;s the best way to solve this: connect the master directly to the receiver and continue configuring it via radio?<br><br> Funke: Graupner MZ18 with SMUD connected to Vstabi NEO<br><br> Regards, Sascha<br><br><br><br> Edited once. Last edited on 16.07.2015 at 15:59 by linksen98.","note":"machine-translated from German"}