{"ok":true,"content":"Hello,<br><br> First of all, I&#39;m a first-timer with my VBar Neo. Please forgive any questions you might be able to answer on the forum.<br><br> In the setup, I set the collective pitch to 13\u00b0 and the cyclic pitch to the default 8\u00b0. The Vstabi is a Neo Express with two Spektrum satellites on a 3-blade Goblin 700 KSE fan.<br><br> If I adjust the collective pitch on the helicopter without a USB connection, it only measures 11.5 to a maximum of 11.8\u00b0. However, in the setup, it shows 13\u00b0 again.<br> Am I doing something wrong, or is this normal?<br><br> You can notice this in flight as well; the climb rate isn&#39;t bad now, but there&#39;s still room for improvement.<br><br> I&#39;d also like to get even more performance out of the helicopter in cyclic mode. I just tried it with the &quot;Agility&quot; setting. Bank 2 - value 90 \/ Bank 3 - value 105, otherwise everything is the same.<br><br> If I switched the benches now, I would have expected a significant increase in maneuverability. However, I didn&#39;t notice any difference. Almost nothing changed.<br><br> How do I configure it so that I can increase the roll and pitch rates?<br><br> Do I need to increase the base values in the setup? Specifically, set the cyclic value to more than 8\u00b0? And the collective value to more than 13\u00b0?<br><br> Greetings from North Rhine-Westphalia!<br><br> Benjamin","note":"machine-translated from German"}