{"ok":true,"content":"First of all, thank you for the feedback!<br><br> The problem is that no connection to the software is established at all; only the USB indicator shows &quot;green&quot; in the software when I apply power to the Neo connected via USB without the bind plug. If I start with the bind plug, not even the USB indicator turns green.<br><br> I followed the instructions exactly, just as you described, but without success. My understanding is that I can register the Neo using the serial number, but I only get the serial number after a successful connection to the software (displayed in the bottom right corner). I&#39;m not getting a serial number displayed (0000000000), even though I&#39;m following the instructions precisely. Therefore, the Neo isn&#39;t registered. Is there another way to register it?<br><br> As I understand it, the update happens automatically using the procedure you described above. How will I know that an update has been performed?<br><br> Thanks in advance!<br><br> Greeting,<br> Udo","note":"machine-translated from German"}