{"ok":true,"content":"Hello,<br><br> Due to the design of the new Vstabi Neo, I decided to implement my setup as follows.<br> The Vstabi is supplied with signals from both the motor and bank channels, and these receive appropriately meaningful signals.<br> These are, as far as I understand.<br> Engine: -100 for Off, 0 for Idle (Bailout), 100 for On<br> Bank: -100, 0, 100 for 1 2 3.<br><br> This works perfectly so far.<br> Since I still want to adjust the controller directly via the transmitter, I thought I would implement this by looping through another channel where I send values to the controller (in addition to sensible inputs in the bank settings for external controllers).<br> This way I can still make small changes to the rotational speed at the transmitter.<br> The controller is then connected not via ESC but via AUX2 or AUX3. ESC remains unused.<br><br> The problem is this:<br> The channels can be assigned accordingly and are displayed in the interface analogously to the settings in the transmitter.<br> However, when I connect the controller, it doesn&#39;t work.<br><br> To test, I connected a servo to see what kind of signals were being output. At the same time, I also checked the outputs in the VBar Setup tab for transmitters. These always correspond exactly to the transmitter&#39;s specifications.<br> I connected my through-hole gas channel to both AUX2 and AUX3 (I also tried them individually).<br><br> Result:<br> The signal at AUX2 is completely garbled. The servo jerks randomly to a different position approximately every 3 seconds. This repeats indefinitely.<br> A signal arrives at AUX3 that is similar to the one I&#39;m setting. However, sometimes it&#39;s delayed, sometimes immediate. Sometimes the servo jumps very abruptly. (I assigned the channel to the pitch stick for testing and observed the movements.)<br><br> The Vstabi Neo is connected via the Futaba S-BUS protocol.<br> PC software version 6.1.0 from May 6, 2015<br> Vstabi Software is Vstabi Rescue 6.1.32<br><br> I have another question. Is there a way to save failsafe values for the AUX outputs?<br><br> I am grateful for any advice.<br><br> Best regards<br><br><br><br> Edited twice. Last edited on 16.07.2015 at 09:44 by fabfour.","note":"machine-translated from German"}