{"ok":true,"content":"Hello.<br> My helicopter crashed for the second time yesterday due to the Neo rescue system.<br> I&#39;ll start with the setup. The helicopter is a Trex 450L, and the transmitter is a DX8. I&#39;m running the Neo with a Hobbywing V3 BEC. The ESC is configured as an external controller. The receivers are two Spektrum satellites. The rescue system is set to rescue only.<br><br> So, the helicopter setup and further configuration were trouble-free, and the helicopter flew perfectly right away. Then, on the third test flight, I deployed the rescue system (push-button switch), and it worked flawlessly.<br> After that, I tested the rescue function twice more during the flight (hovering at about 8m altitude), where the helicopter then gave negative pitch on the 3rd attempt and crashed uncontrollably.<br> Unfortunately, I haven&#39;t yet had the chance to read the event log in that situation.<br> So I rebuilt the helicopter and, to rule out any errors, started again with a completely new Neo and transmitter setup.<br> Everything was working perfectly again, the rescue system even functioned flawlessly at least 20 times. I tested everything at a considerable altitude. Then, during another rescue test, the helicopter became uncontrollable again and crashed. It was impossible to override the rescue system.<br> After the rescue, I found the following entries in the event log: Pitch and Roll Sensor outside of measuring range<br> So I can no longer install the Neo, and I assume it&#39;s a hardware defect that has now cost me 2 helicopters and many hours of work.<br> What is the best way to proceed in such a case?","note":"machine-translated from German"}