{"ok":true,"content":"Hello,<br><br> I have completely and neatly assembled my new T-Rex 450L dome, including the Neo installation. So far, everything works as it should on the workbench, except for the rescue function.<br><br> I tested the activation from an external transmitter in the PC software \u2013 everything is OK. I calibrated the rescue system, setting the pitch to 65 and the cyclic ring to the default. The log file also documents the rescue function as &quot;started&quot; and &quot;ended.&quot; Only &quot;rescue&quot; is activated.<br><br> The helicopter shows absolutely no reaction to the activation of the rescue function. I switched it on in normal flight mode (two motor wires disconnected), moved and tilted it a bit, then switched it off again and set the pitch to negative. I took my hands off the transmitter and pulled the rescue switch \u2013 absolutely no reaction, neither roll\/pitch nor pitch. I also tried tilting the helicopter slightly and pulling the rescue switch \u2013 still absolutely no reaction. As I said, the log file shows the rescue started and ended two seconds later. I tried the same thing with my laptop connected in the software&#39;s settings mode, same result \u2013 nothing.<br><br> How can I test the rescue system on the workbench? Am I doing something wrong? Does the engine need to be running (I haven&#39;t done this yet for safety reasons, disconnecting two cables)?<br><br> I absolutely want to test the rescue system before the maiden flight.<br><br> Thank you for your help!<br><br> Greeting,<br> Udo","note":"machine-translated from German"}