{"ok":true,"content":"Hello,<br><br> I have a VBar Neo Express, with GR24 (Graupner\/SJ):<br> Everything is OK so far, registered, key file loaded, VBar connected to computer, receiver set (SUMD), channels assigned, center and end positions verified\/adjusted in transmitter.<br><br> All signals are being received; I can clearly see this in the VBar software&#39;s bar charts. VBar is showing a green light.<br><br> However: the servos move to the center position (swashplate), and the tail servo receives no signal. I can neither change the direction of rotation, adjust the servo center positions, nor modify the pitch values. These settings are available in the software; however, the servos remain stuck in the center position. Furthermore, upon power-up, the servos immediately spring to the center position, and the swashplate does not move.<br><br> What have I forgotten or set incorrectly?<br> VG Andreas","note":"machine-translated from German"}