{"ok":true,"content":"Hello Rainer,<br><br> I ignored your test and re-calibrated the controller properly and also did the fine-tuning directly.<br> The nice thing about my controller is that it shows me via LED when the motor is off or at full throttle, and I then set it 5 points lower or higher.<br> Now, the setup software also correctly displays engine off and full throttle.<br> Since the helicopter was already standing there without blades, I immediately tested the failsafe by switching off the transmitter and unplugging the receiver; both times the motor stopped.<br><br> I still have one problem: When starting the motor in my 700, the starting torque is too high; with the first jerk, it hits the blades against the blade holder, after which it runs up slowly. I have already reduced the start-up speed to 2.<br><br> Is there a setting for the starting torque here, or am I just left with tightening the blades more? ;-)<br><br> If I can solve this, you&#39;ll get a lamb chop.<br><br> Regards, Lars","note":"machine-translated from German"}