{"ok":true,"content":"Hello everyone,<br><br> My helicopter just came down without responding to my control inputs.<br><br> I personally find nothing special in the log, apart from a few errors (numbers 135 and 139) which have no description.<br><br> I&#39;ve attached the log as screenshots, you can take a look.<br> Before anyone complains - the save function doesn&#39;t seem to work for me - it just creates an empty PDF and the mouse cursor keeps spinning without doing anything.<br><br> In any case, the helicopter came down without responding to any control input. Given this symptom, I would have expected something like signal loss, low BEC voltage, or simply an abrupt end to the log. But none of that is found in the log.<br><br> Setup used:<br><br> Graupner MZ-24<br> Graupner GR-24 receiver \/ summed signal<br> Vbar NEO<br> Cool Kosmik 160<br> Pyro 800<br> TT DS1015 on TS<br> TT DS6060n at the rear<br><br> In the event of a failsafe, the Neo was configured to shut off the motor. I had tested this shortly beforehand, and it was clearly recorded in the log \u2013 therefore, the receiver configuration is also correct.<br><br> Unfortunately, I don&#39;t currently know why the helicopter stopped responding - but perhaps one of you might have an idea what the cause could be.<br><br> Thanks in advance for your help!<br> Stefan<br><br>","note":"machine-translated from German"}