{"ok":true,"content":"Where is the servo connected?<br><br> If you&#39;re using an external controller, we&#39;re assuming an electric helicopter with a linear throttle. That&#39;s definitely not suitable for a nitro helicopter. We also haven&#39;t considered the &quot;without governor&quot; scenario. We fly everything with governor.<br><br> Configure it like this, that should work:<br><br> - Make Nitro Governor config<br> - Omit the RPM sensor (you&#39;ll constantly have messages in the log)<br> - possibly provide a bench for the high-jumping bench<br> - Set to idle on workbench (test run without leaves)<br><br> - Now set the pitch enhancement to 0 for all banks (RPM).<br> - Let the helicopter start up at zero pitch<br> - Process the base gas until it matches the zero-pitch gas for this RPM.<br> - then hover - and adjust the pitch adjustment here so that the RPM is OK.<br><br> So you have 3 3-point-V throttle curves or 2 3-point-V and one rev-up curve.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}